![]() ![]() This means that the conical part of the tool exits from the material. The drilling is performed until the given diameter is reached at the specified Drill depth. #How to set the default drill cycle options in inventorcam fullIn the Depth type section, choose the Full diameter option. ![]() To perform through drilling, use the Depth type option. Define the Drill depth by clicking the model face as shown. Define the Drilling depth In the Levels page, define the Upper level by clicking the model upper face. Choose the Tool #7 (Ø5 Drill) from the Part Tool Table. Choose the same Drill geometry used in the previous operation. Add a Drilling operation In InventorCAM Manager, add a new Drilling operation to drill the holes center-drilled at the previous stage. Simulate Play the simulation of the center drilling in the SolidVerify mode. The Drilling operation data is saved and the tool path is calculated. Save and Calculate Click the Save & Calculate button. ![]() The upper diameter of the center drilling cone is greater than the drilled hole diameter this means that the chamfer of 0.25 mm is performed at the hole edge. The center drilling operation is performed until the specified diameter is reached at the upper level (the top face of the model). In the Depth type section, choose the Diameter value option and set the value to 5.5 mm. To perform center drilling, use the Depth type option. Define the Drill depth In the Milling levels area, set the Drill depth to 0. The Drilling Operation dialog box is displayed. Confirm the tool definition by clicking the Select button. In the Part Tool Table, choose the Tool #6 (Ø6 Spot drill) for the operation. 145Ĭlick the OK button to exit from the tool library. The tools are imported into the Part Tool Table. Click the Import All Tolls button ( ) located in the left bottom part of the dialog box. Click the Browse button and choose the location of the Exercise3_Drill_Tools tool library. The Import from Tool Table dialog box is displayed. InventorCAM 2.5D Operations In the Part Tool table, click the Import ( ) button to import the tool from the previously defined tool library. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |